Dell Wyse DX0D ThinOS conversion kit, MNT Installation Guide

Installation GuideWyse® D Class Conversion to ThinOSWyse® USB Firmware ToolTM Release 1.19Products: D50D, D90D7, D90DWIssue: 080113PN: 883887-35L Rev.

6 Chapter 2Figure 6 Browse to select commandsXml.xml8. Navigate to the D Class ThinOS Conversion Image folder on your hard drive (this is the location

Converting Wyse D Class to ThinOS 7Step 4: Use the Configured USB Key to Install Firmware on Each Thin Client In this step, you will boot each thin cl

8 Chapter 2Step 6: Update the BIOS on Each Converted Thin ClientIn this step you will use the USB Firmware Tool to update the BIOS of each thin client

Converting Wyse D Class to ThinOS 9Step 8: Obtain a Firmware UpdateIf you are under a Wyse maintenance contract, you can download ThinOS software upda

10 Chapter 2TroubleshootingThis section contains general troubleshooting information.USB Keys - Troubleshooting Boot IssuesDue to different manufactur

Converting Wyse D Class to ThinOS 11This page intentionally blank.

Installation GuideWyse® D Class Conversion to ThinOSIssue: 080113Written and published by: Wyse Technology LLC, August 2013Created using FrameMaker® a

Copyright Notices© 2013, Wyse Technology LLC. All rights reserved.This manual and the software and firmware described in it are copyrighted. You may n

Contents1 Introduction 1Kit Contents 1Wyse Technical Support 2Related Documentation and Services 2Wyse Online Community 22 Converting Wyse D Class to

iv ContentsThis page intentionally blank.

1 IntroductionThis guide provides the instructions you need to install and use Wyse® USB Firmware ToolTM to convert the following Wyse D class thin cl

2 Chapter 1· bios.imgWyse Technical SupportTo access Wyse technical resources, visit http://www.wyse.com/support. If you still have questions, you can

2 Converting Wyse D Class to ThinOSThis chapter includes the requirements and procedures you need to install and use Wyse® USB Firmware ToolTM to upda

4 Chapter 2ProceduresIMPORTANT: Complete the following procedures as an administrator (administrator privileges are required).Step 1: Copy the D Class

Converting Wyse D Class to ThinOS 5Figure 3 Configuration options3. Select the Configure the USB key to Copy/Pull or to Update/Push firmware option, a